When you will use the solar panel as a source of electricity, you will need a charge current controller to match the charge voltage. After all, the 20A UKC LD-520A Solar Panel Charging Controller for UKC LD-520A Solar Panel ensures long battery life and promotes conservation.

The Charging Controller for Solar Panel UKC LD-520A a has several modes of operation, two of which are interrupted during the charging process, one of which is invariably the interval of operation of the RWH intelligence during the charging process. By the ripple you can detect how the charging process itself is going. The device does not charge badly, but the frequency is low for faster recharging and desulfatization mode. The device has an audible signal that warns about the lack of voltage.

The device is made in a very good case, which is designed just for this board! The board inside the device is made very well, as the soldering is made on 5 points, and protection of the board in the form of varnish, this is the first controller that is so well filled with it. The board of the device has revision 1.0. The firmware in it is made quite modern, it shows that this charging controller for solar panel UKC LD-520A is not stamped continuously in one case and with one firmware.

Key Specifications:

- Model: LD-520A;

- Power supply voltage: 12V, 24V;

- Maximum load current: 20.0(A);

- Maximum input voltage: 100V;

- Controller type: PWM;

- Electronic protection: Short circuit and polarity reversal;

- Operating Temperature: -20ºC +55ºC;

- Device Protection Rating: IP32;

- Dimensions of liquid crystal display: 45 x 25 mm;

- Overall dimensions: 160 x 85 x 35 mm;

- Weight: 150 grams.

Accessories:

- UKC LD-520A 20A Solar Charging Controller UKC LD-520A;

- Instruction;

- Packaging.